
It consists only of doubling the PA transistors. The original 4 BS170s are paralleled with 4 more as shown in my implementation in the image. Very simple!
It is, as far as I understand, the brain child of Roelof PA0RDT and is described in detail on the QRPLabs website. I essentially followed those guidelines, and got more or less the same results as reported there.
There are several advantages:
- Approximately doubled output power
- More robustness to applied voltage. My QMX, wired for 9 Volts, now runs fine on 11 and more Volts, with a current limited power supply (approx. 2 Amps).
I have had many FT8 contacts with it - where the transmitter is on continuously for 13 seconds - and have not had any problems. The only downside that I have heard of is slightly reduced power on 6 m due to the effect of the increased gate capacitance with two instead of one transistor.
however is seems to be smart solution, it will never improve the thermal resistance and eventually linearity for linear operation. This is weakness of the whole solution.
ReplyDeleteThermally all experience seems to indicate that it us adequate. And when it comes to linearity, then I don't see the relevance for a digital stage like this
Delete