What it takes to make the AP510 APRS tracker useful

This small VHF APRS tracker can easily be improved with some simple measures:

1. The 1 Watt of output power is often too little to reach the desired APRS digipeater reliably enough. It is much simpler to improve the antenna than to add an amplifier and it can be done as follows:
• Use a longer telescopic antenna. In the picture I have used an antenna that can be extended from 16.5 cm to 45.2 cm. Depending on how you use the tracker, always extend the antenna as much as practically possible.
• Add an external counterpoise or "tiger tail" of length a quarter of a wavelength. That's about half a meter. In the picture it is fastened on the antenna's BNC connector by means of an 8 mm ring terminal.
2. Update the firmware, if you haven't done so already, to the version from 3 Nov 2015. I have written before about my experience with that firmware.
3. Get rid of the pirated USB chip in the interface cable. I did that last year and now interfacing it to the PC and updating it is so much simpler.

These simple steps have made my AP510 tracker much more useful.



The post "What it takes to make the AP510 APRS tracker useful" first appeared on the LA3ZA Radio & Electronics Blog.

Latest firmware for AP510 APRS tracker is superb

I got my AP510 APRS tracker a little more than a year ago. It kind of worked, but not very well in my car. But after the tracker got a new firmware dated 3 Nov 2015, it has become so much better. Now I can say that it is really useful.

AP510 with original short antenna
and telescopic antenna

Apparently, the Smartbeacon function didn't work properly in earlier versions of the firmware. With some good debugging and error reporting by KC5EVE, Mark, working with the software developer for the AP510, BG6QBV, the annoying errors now seem to be gone. This is all documented in the Yahoo AP510 group.

I have fitted mine with a 16-45 cm telescopic antenna and even when attached to one of the rear headrests in my sedan, the 1 Watt of output power tracks very well.

The map below shows a drive from Telemark, about 100 km west of Oslo, to Oslo with as good coverage as one can expect given the valleys and the availability of APRS digipeaters especially in the western part.

Note the missing tracks east of LA5PPA-1 which are due to a 3.5 km long tunnel,
Strømsåstunnelen, between Drammen and Mjøndalen.

Finally got rid of the pirated USB chips for the UV-5R and the AP510

Both the Baofeng UV-5R handheld UHF/VHF radio and the Sainsonic AP510 APRS tracker come with interface cables with pirated chips. These are clones of Prolific USB/serial chips. Since Prolific has taken measures against this, only old drivers will work with them. That means that one has to stop automatic driver updates as explained on the Miklor site for the Baofeng UV-5R. The same is true for the AP510. This is a nuisance.

I got tired of this and got myself some USB/serial modules from Ebay based on the CP2102 chip instead. The cost was US $1.43 a piece so it should be affordable for anyone. I also got some clear heat shrinkable tube.

Waiting for an AP510/AVRT5 APRS tracker

I just ordered an AP510/AVRT5 APRS tracker and am anxious to get my hands on it to try it out. I like the small size and the fact that it is self contained - no external wires are needed to have a fully functional tracker for the automatic packet reporting system APRS: But is it useful or just a toy?

The specifications from the Amazon.co.uk site are (adapted from Chinglish):

• SainSonic AVRT5 APRS Tracker VHF with GPS/Bluetooth/Thermometer/TF Card, Support of APRSdroid
• GPS module: SIRF3 module, high sensitivity, fast positioning, stable power.
• GPS antenna: 18mm x 18mm active GPS antenna, built-in LNA amplification, Star Search, locate quickly.
• VHF Module (1W): The latest 1W VHF transceiver modules, small size, high stability for all types of wireless data transmission.
• VHF antennas are individually matched to transmitter to ensure that the standing wave ratio is proper and the emission is efficient.

I also signed up for the Yahoo group AP510 AVRT5 APRS.

What attracted me were the reviews given by DK7XE, DJ7OO (German), and APRS.facile.fr (French) and the descriptions at Radioddity and Sparky's blog,

It is evident that the 2. harmonic suppression leaves something to be desired, that the antenna is inefficient, that the programming interface isn't the easiest to deal with, and that it can be hard to set the frequency for people in countries such as Norway with PC's set for "," rather than "." as the decimal point. Hopefully I can figure out ways to deal with all these and also other issues that may show up.