22 October, 2016

What it takes to make the AP510 APRS tracker useful

This small VHF APRS tracker can easily be improved with some simple measures:
  1. The 1 Watt of output power is often too little to reach the desired APRS digipeater reliably enough. It is much simpler to improve the antenna than to add an amplifier and it can be done as follows:
    • Use a longer telescopic antenna. In the picture I have used an antenna that can be extended from 16.5 cm to 45.2 cm. Depending on how you use the tracker, always extend the antenna as much as practically possible.
    • Add an external counterpoise or "tiger tail" of length a quarter of a wavelength. That's about half a meter. In the picture it is fastened on the antenna's BNC connector by means of an 8 mm ring terminal.
  2. Update the firmware, if you haven't done so already, to the version from 3 Nov 2015. I have written before about my experience with that firmware.
  3. Get rid of the pirated USB chip in the interface cable. I did that last year and now interfacing it to the PC and updating it is so much simpler.
These simple steps have made my AP510 tracker much more useful.



The post "What it takes to make the AP510 APRS tracker useful" first appeared on the LA3ZA Radio & Electronics Blog.